This is the most comprehensive workshop manual available for the Turbo Hydra-Matic and Turbine 400 Transmissions.
Suitable for the home workshop mechanic or professional technician, this manual will help you maintain your Turbo Hydra-Matic and Turbine 400 Transmissions. Very easy step by step instructions with lots of diagrams.
This Turbo Hydra-Matic and Turbine 400 manual covers the following models fitted with these transmissions:l
- Buick models 1964-1965
- Cadillac models 1964-1965
- Oldsmobile models 1964-1965
- Pontiac models 1964-1965
Below is a list of procedures covered in this manual:
- REMOVAL OF MAJOR COMPONENTS FROM THE TRANSMISSION CASE
- Governor. Speedometer Driven Gear, Oil Pan. Strainer and Intake Pipe Removal
- Control Valve Assembly. Governor Pipes and Detent Spring Assembly - Removal
- Rear Servo. Solenoid. Connector. ValveBody Spacer. Gasket. Front Servo.Manual Detent and Park Linkage Removal
- Rear Oil Seal and Extension Housing Removal
- Turbine Shaft. Forward Clutch. Direct Clutch. Front Band. Sun Gear Shaft Intermediate Clutch. Center Support- Removal
- Disassembly of the Gear Train Assembly
- Governor Assembly
- Front Servo Disassembly. Inspection and Reassembly
- Rear Servo Disassembly, Inspection and Reassembly
- Control Valve Assembly. Disassembly. Inspection and Reassembly
- Oil Pump Disassembly. Inspection and Reassembly
- Forward Clutch Disassembly. Inspection and Reassembly
- Direct Clutch and Intermediate Sprag Disassembly. Inspection and Reassembly
- Center Support and Intermediate Clutch Disassembly. Inspection and Reassembly
- Inspection of the Reaction Carrier. Rear Sprag and Output Carrier Assembly
- Pinion Replacement Procedure
- Inspection of the Output Shaft
- Inspection of the Rear Internal Gear
- Inspection of the Sun Gear
- Inspection of the Sun Gear Shaft
- Inspection of the Turbine Shaft
- Inspection of the Mainshaft
- Inspectioll of the Front and Rear Bands
- Inspection of the Case Extension
- Inspection of the Modulator Valve
- Inspection of Manual and Parking Linkage
- Inspection of the Case Assembly
- Inspection of the Torque Converter
- Assembly of the Rear Unit
- Assembly of Units Into the Transmission Case
- Rear Extension Housing Assembly
- Installation of Manual Linkage
- Installation of Check Balls. Front Servo. Gaskets. Spacer and Solenoid
- Installation of Rear Servo Assembly
- Installation of the Control Valve Assembly and Governor Pipes
- Installation of the Modulator Valve and Vacuum Modulator
- Installation of the Governor Assembly
- Installation of the Speedometer DrivenGear Assembly
- OPERATION OF THE TURBO HYDRA·MATIC -TURBINE "400" TRANSMISSION
- Description and Mechanical Operation
- Hydraulic Operation
- Diagnosis Chart
- Diagnosis Procedure
- Diagnosis Sequence
|
